Level the anchor nearest the pool with the existing concrete, the back anchor should be level with the front anchor. You will have only a short time to adjust the anchors before the cement sets. Set the jig in the hole and pour the anchoring cement around the jig and part way up on the anchors. Put tape over the holes on the top of the anchors. Next you will need a small level and anchoring cement (Home Depot or Lowes). If you do not have an expansion joint behind the coping or you have a cantilever deck then its choice one. Choice two is to put the bond wire behind the coping in the expansion joint and run the wire down to the best deck expansion joint to your equipment pad. Choice one is to cut a saw joint behind the new anchor hole and run the bond wire in that and back to your equipment pad. Next dig out your hole so that the bolts will fit with two inches room when the anchors are flush with the deck.Īt this point you will need to determine how you are going to run the bonding wire. Tighten the nuts and lock washers so the bolts do not move. On the anchor jig there will be some holes, use these to put in two stainless steel bolts on the bottom of the jig (4" or more) with stainless steel nuts and lock washers on the under side and the top side. Cut out a rectangle using the jig as your template making the rectangle bigger than the jig but smaller than the escutcheon plate. I would use the brass anchors (better for salt pools) and an anchor jig that fits the width of your handrail. This link helps explain bonding and grounding This post may be to late but it could help some one else. A 4" core bit and a powerful hammer drill makes for the nicest work but not something everyone has in their shop. Of course, the hard part is getting a uniform hole in that twenty-year old concrete. You can then remove the rail anytime you choose. Then, simply place the rail inside the anchors and tighten the bolts onto the rail. Set the plastic anchors into the same mix and smooth and level it quickly. If you get the hole too big, the escutcheons will not cover your work. ![]() Make holes in the concrete big enough to accept the anchors with just enough clearance to get a little cement around them. Give it another minute and slide the escutcheons down over your work and enjoy!Įssentially the same process except you'll need two rail anchors made specifically for pool rails and ladders. Then, with the rail out, fill the holes about 90% full of the mixed anchor concrete (You've got about 1 minute from this point), and quickly place the rail down into the mix and resting on the prebuilt brace. Next build a brace that will allow you to quickly set the rail in it's correct position inside the holes. Then, if you don't have them already, you can get plastic escutceons that will cover the new cement you're about to pour. It sets up VERY fast so be fully prepared before using it. Get a product (at HD/Lowe's) made by Sakrete called "Anchor" "Bolt and rail cement". There's two ways to fix it.permanently and removable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |